NOVA 200 M-NA
TECHNICAL DATA
Flow rate: From 1 m3/h to 16 m3/h
Head: 10,2 m
Pumped liquid: Clean water, rainwater
Free passage: 5 mm
Liquid temperature:
from +0°C to +35°C for domestic use
from +0°C to +50°C for other use
Outlet: 1" 1/4 GAS
Outlet direction: Horizontal or vertical
Impeller: Vortex in technopolymer
Motor protection degree: IP 68
Thermal classification of the motor insulation: F
Power cable type: H05RN-F
Possible type of installation: Fixed or mobile in vertical position
Maximum immersion depth: 2 or 7 meter depending on the length of the cable
Submersible pump for draining clear and rainwater in residential building service.
The pumps was redesigned on the occasion of the forty years of sales, it has been made even more reliable, resistant and ergonomic. It has a new treated cable and a new motor, more compact and efficient. There is also a sealed cable gland.
It can also be used for emptying tanks or cisterns.
In compliance with the European standard EN 60335-2-41, the 10 meter power cable is mandatory for the pump for the outdoor use.
A 90° fitting is provided for vertical discharge.
CONSTRUCTION FEATURES OF THE PUMP
The pump body, the Vortex impeller and the suction grille are in technopolymer.
The pump are sturdy and reliable with triple ring seal in oil bath. The pump allows the suction of the liquid up to the minimum level of 8 mm and the possibility of dry run-up to one minute. There is a seal on the impeller bolt to prevent corrosion on the bolt motor shaft.
CONSTRUCTION FEATURES OF THE MOTOR
New, more compact and efficient motor. Continuous duty asynchronous submersible motor. Stator housed in a hermetic stainless steel casing and rotor mounted on oversized ball bearings. The motor shaft is in stainless steel AISI 431, the pumps is suitable for slightly salty water.
The thermal protection is incorporated in all single phase versions.